COPA-DATA Self Service Portal

Disclaimer

This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

COPA-DATA reserves the right to change this document from time to time at own discretion.


Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com

    • Most Discussed Topics

    • Combined element ALC activation with 2 instead of 1

      Hello, Is it possible to change ALC activation from 1 into 2? Our client gave us variables where 0 is intermediate and 1 is off and 2 is on, so I only need for combined elements to let color through when the variable is 2. How could i achieve this?

    • Combined element ALC activation with 2 instead of 1

      Hello, Is it possible to change ALC activation from 1 into 2? Our client gave us variables where 0 is intermediate and 1 is off and 2 is on, so I only need for combined elements to let color through when the variable is 2. We are using OPC UA drivers

    • New proyect

      I´m just finish to install Zenon 15 and i can´t create a new proyect

    • Sending Double-Point Command via IEC 60870-5-104

      I would like to send a double-point command to a PLC via IEC 60870-5-104 communication. I have created a variable with IEC type T46 and a boolean data type. I would like to know how to properly send a double command to the PLC — should I create a write

    • Report Generator

      i have a report generator license in the demo mode but i can not find the " report generator " screen in the screen type menu when adding a new screen ?