object explorer in the screen

object explorer in the screen

Hi everyone,

I quite new in Zenon but have experience on other HMI software.
one of the feature that i'm quite fond in other engineering tool is object explorer that can show you all the element present on the screen and you can select it from there.
this is specially useful when you have multilayer screen.
I was wondering if there is a way to have an object explorer in engineering studio?
if not would be possible to program either a VBA or addin to add this functionality.
thanks for your support.

Regards,
Abdallah

    Disclaimer

    This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

    The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

    Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

    Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

    COPA-DATA reserves the right to change this document from time to time at own discretion.


    Ing. Punzenberger COPA-DATA GmbH
    Karolingerstraße 7b · 5020 Salzburg · Austria
    www.copadata.com