Can't start Runtime if editor and runtime are in demo mode and language is French

Can't start Runtime if editor and runtime are in demo mode and language is French

Description

If zenon is used in demo mode and in French, the Service Engine (aka "Runtime") cannot be started from the Engineering Studio (aka "Editor"). Just an error message is displayed, the start is prevented.

This error has been fixed. The Service Engine starts again as expected.

To benefit from this fix:

  • Update your zenon Software Platform to the latest build of zenon 8.00 or higher.

 



Item ID: 135382
Version: 8.00 Build: 48821

    • Related Articles

    • Can't start Runtime if editor and runtime are in demo mode and language is French

      Summary correct rfrance_u.rc - translation included wrong interpretation of placeholder changes will be merged to 8.10 by using the corrected French VisLoc file Description correct rfrance_u.rc - translation included wrong interpretation of ...

    • Checklist: zenHelpService cannot start

      Time estimate: 15 minutes Please go through all the items in the following checklist. If necessary, confirm any information you cannot verify with the IT department before contacting your local COPA-DATA representative. If during the installation of ...

    • Checklist: Engineering Studio cannot start or closes unexpectedly

      Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

    • 'T' cannot be translated

      Summary In the module Batch Conrol there are several spots where durations can be configured. The format of these properties is '0T 00:00:00' where 'T' stands for the German word 'Tag' ('day' in english). It is, unfortunately, not possible to ...

    • FAQ: What are the different zenon drivers modes?

      All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...