COPA-DATA Self Service Portal

Disclaimer

This document governs the use of our Community Forum. By registering and using the platform, you accept these conditions.

The COPA-DATA Community Forum serves to encourage the exchange of information and experience about the zenon software between forum users respectively zenon users.

Please mind that any published information on the Community Forum is the subjective opinion and view based on the experience and the level of knowledge of the author. COPA-DATA does not overtake any responsibility for the content and the accuracy of the shared information.

Users of the Community Forum are encouraged to share only well-founded experiences and to point out any risks associated with the implementation of proposed solutions to problems. COPA-DATA at its absolute discretion, reserves the right to moderate the forum. In this connection COPA-DATA may remove any information containing false facts, potentially dangerous solutions, bad language or content that may insult, degrade or discriminate others. COPA-DATA may block a non-complying user from forum access if the user violated this provision.

COPA-DATA reserves the right to change this document from time to time at own discretion.


Ing. Punzenberger COPA-DATA GmbH
Karolingerstraße 7b · 5020 Salzburg · Austria
www.copadata.com

    • Most Discussed Topics

    • Zenon Redundancy

      Greetings, Long time since my last post. I need all sections within Zenon (V11) documentation about redundancy. I have 2 servers with Logic drivers working on both. Server 1 (primary) > at normal conditions, the Logic drivers should be active and running.

    • 3 Frames 1 Screen

      I have three different frame sizes with the same zoomable content screen: Frame 1: 1920 x 1080 Frame 2: 3840 x 1080 Frame 3: 7680 x 1080 Is this possible? What is the best way to achieve this?

    • Logic redundancy (Standby mode)

      Hello Zenon Community, I have an issue with logic redundancy. I have SERVER-1 and SERVER-2. I share my settings for logic properties below. The issue is that the logic service does not work in the standby regime. I can download logic to just one server,

    • "Move frame via mouse" function over Dynamic text

      Hi Everyone I am using the "Move frame via mouse" feature to be able to move the screen position when starting the service engine. However, currently, when I place the mouse cursor over a "Dynamic text" element, I can't move the screen, while it works

    • Zenon Logic: Gateway configuration

      The gateway configuration (IEC 61850 TO IEC 104) in Zenon Logic was already set up. Recently, due to a malfunctioning IED, a new IED was installed, and the old variables on the gateway were replaced with new ones. While most variables compiled successfully,