Summary Beckhoff TwinCat NG driver blocks Service Engine when switching to Stop/Simulation driver mode. This has been fixed. Description When the Beckhoff TwinCat NG driver switches to Stop or Driver Simulation mode, it blocks the Service Engine for ...
All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...
Description When importing variables from its TPY file, the Beckhoff TwinCat NG driver imports arrays incorrectly. The cause is that the selection is based on the ID (decoration), but if IDs are present more than once, the data type cannot be ...
Summary When starting the OPC2CLI32 driver in mode Simulation - static and then switching to mode Hardware during runtime, the variables of the OPC2CLI32 driver become invalid. Description When starting the OPC2CLI32 driver in mode Simulation - ...
Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...