zenon Logic iec850-90-5 driver: in one cycle the Logic program can have data received by different frames of same sampled values.

• Related Articles

• zenon logic: Unexpected complex data in expression

  In zenon version 8.20, it was possible to initiate and assign the function block in one line. This was not IEC compliant, therefore feature was removed in zenon 10. Now the error message "Unexpected complex data in expression" is logged when using ...

• zenon Logic IEC61850-90-5 driver: first received values are lost (zero instead).

  Summary zenon Logic IEC61850-90-5 driver: first received values are lost. In the Logic Runtime program variables have value 0. Description zenon Logic IEC61850-90-5 driver: first received values are lost. In the Logic Runtime program variables have ...

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• FAQ: How to address Logic service cycle overflows?

  In some cases, Logic Service may not respect the configured cycle time of the Logic application. When this happens consider the following: Check Windows Event Logs - System Event ID = 37: The speed of processor x in group y is being limited by system ...

• The IEEE C37.118 synchrophasor driver in the zenon logic runtime sends transmission-on every runtime cycle

  Summary Every runtime cycle the zenon logic IEEE C37.118 synchrophasor driver sends transmission-on until data is received. Description Every runtime cycle the zenon logic IEEE C37.118 synchrophasor driver sends transmission-on until data is ...