When using the function block DTCurDateTime in a Driver Simulation Project, the Output is GMT instead of the local time.

• Related Articles

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• FAQ: What is the time zone and time format used in zenon Software Platform products and what needs to be considered?

  When you ask someone what the time is, they'll usually be able to tell you. But when you ask them what date and time sunrise was yesterday in a different country on a different continent, in a different hemisphere it gets less easy. Terms like GMT ...

• zenon logic: Unexpected complex data in expression

  In zenon version 8.20, it was possible to initiate and assign the function block in one line. This was not IEC compliant, therefore feature was removed in zenon 10. Now the error message "Unexpected complex data in expression" is logged when using ...