When IEC850 driver is configured to "Use Report-ID for RCB assignment" then it uses the globally configured TrgOps instead of the TrgOps per RCB

• Related Articles

• When in Data Model of 850-Server the BRCB.rptID is empty then the IEC850 driver is not able to "Use Report-ID for RCB assignment" and is not storing EntryID to acquire buffered events after reconnect.

  Summary According the IEC61850 Standard when RptID is empty then it means that it in Reports it will be the ObjectReference to RCB, e.g. "IEDNameLDInst/LLN0$BR$brcbST01". At the communication start or online browsing of available RCBs the IEC61850 ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• Wizard IEC61850 driver configuration incorrectly configures report (RCB)

  Description When configuring an IEC850 driver with the IEC850 Driver Configuration Wizard, errors occur in the RCB references. An incorrect RCB name is configured for the client assignment. This error has been fixed. RCBs are configured correctly ...

• Checklist: zenon Driver does not start in zenon 11 Engineering Studio / Service Engine.

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. In zenon 11 and newer versions, ...

• iec850 driver during RCB enabling writes OptFlds also when should 'use preconfigured (SCL) options'

  Summary The IEC850 Client driver can be configured to do not overwrite Report Control Block attributes when they are not dynamical - checkbox 'use preconfigured (SCL) options'. This driver setting should also protect against write of OptFlds ...