Variable not displayed correctly in Logic Workbench

• Related Articles

• zenon Logic: structures which are created in zenonED are not loaded correctly in the Logic Workbench.

  Summary structures with items using structures are loaded on first opening of logic workbench project correctly. Description structures with items using structures are loaded on first opening of logic workbench project correctly. Information Reopen ...

• zenon Logic Workbench and Runtime parameters for Target Host and Target Port cannot be correctly modified in the Editor.

  Summary It is not possible to correctly modify the Workbench/Runtime Host and Port parameters of a zenon Logic Project in the Editor. After the first modification, it is no longer possible to revert to the original settings. DescriptionIt is not ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• When using a driver in mode Simulation - programmed, in the zenon runtime an empty string of a variable of type string can`t be read when setting an empty string via the zenon logic workbench.

  Summary An empty string can`t be read in the zenon runtime when using a driver in mode Simulation - programmed and setting an empty string via the zenon logic workbench. Therefore in the zenon runtime the string variable still shows the prior string ...

• Under specific circumstance the flashing of the Glow Effect weren't displayed correctly.

  Summary When a variable was created with limits and an attribute flashing was also linked to it, at the zenon Runtime the blink effect were not displayed correctly. DescriptionWhen a variable was created with limits and an attribute flashing was ...