TREND: Multi-select changes to curves renames all curves to the same name as the first curve.

• Related Articles

• ETM - Multi-select and multi-edit possibility for trend curves

  Summary ETM allows multi select and multi edit for trend curves. Description From now on, both in the Engineering Studio as well as in the Service Engine, several curves of Extended Trend can be edited at the same time. To enable quick changes, ...

• Extended Trend curves not displaying when first curve is not active

  Summary When a Extend Trend screen displays more than one curve, if the first curve is disabled by the user (active off) and the remaining curves are still active, these also aren't shown >> Are also cleared from the trend. Note: this only occurs if ...

• Filter settings on curves list in extended trend filter are reset after Add/Edit/Delete curve

  Summary On curves list in extended trend filter the settings lost filter settings if the configuration dialog is open. DescriptionOn curves list in extended trend filter the settings lost filter settings if the configuration dialog is open. Solution ...

• The curve name in extended trend is cut if longer than the defined colum size

  Summary In the screen switch function for an extended trend when adding a curve with the name like: 'MPLC.TSMU/AscentSys.VacuumPumps.P1.ACP_Inverter.Cmd.test' it will be cut to 'MPLC.TSMU/AscentSys.VacuumPum' Description In the screen switch function ...

• The runtime closes unexpectedly when a user changes between data sources for a curve in the extended trend in the runtime

  Summary The runtime closes unexpectedly when a user manages to change between data sources for a curve in the extended trend in the runtime. Per definition, the data source for a screen switch function to the extended trend does not allow changing ...