The status icon of a phase in Batch Control does not update correctly when a communication error is acknowledged and the phase state is aborting.

• Related Articles

• FAQ: How can I monitor and react on the communication status of my devices with zenon?

  Data quality is very important to the integrity of a HMI or SCADA system. As such, zenon has numerous ways to monitor the communication status of different devices within your automation environment. Here are some options that you can use in your ...

• Batch Control: Switch Phase option doesn't update control strategy list control which can lead to write wrong parameters

  Summary In Batch Control, switching between phases in the same unit is not done correctly. This has been fixed. Description When switching from one phase to another phase of the same unit in Batch Control with "Switch phase", the control strategy is ...

• Batch Control: Switch phase doesnt work properly for similar units

  Summary In Batch Control, switching between phases of different units is not done correctly. This has been fixed. Description If control strategy is used in Batch Control, the parameters of the control strategy are retained when switching from one ...

• Batch Control - Phase edit dialog is no longer resizable

  Description In Batch Control, the "Edit phase" dialog can no longer be resized. In certain constellations, the dialog is opened in such a way that the gripper icon cannot be operated correctly. This mainly occurs when the dialog is opened on a ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...