The Ethernet IP I/O Scanner does not reconnect properly if several Adapters are connected and rebooted

• Related Articles

• New Ethernet/IP Scanner block to restart specific IO connection

  Logic Service fieldbus "Ethernet/IP Scanner" driver allows to restart IO connection of a specific EIP adapter (IP address) using the block EIPRESTARTCNX. The EIPRESTARTCNX block is available since zenon 10 build 138660. Refer to product documentation ...

• zenon Logic: Ethernet/IP Adapter and Ethernet/IP Scanner will not be started in Logic Service

  Description In zenon Logic ServiceEthernet/IP Adapter and Ethernet/IP Scanner are not started, although they were configured correctly in Logic Studio. When starting the Logic Service they are not started as expected. Diagnosis Viewer logs indicate ...

• It is not possible to use the zenon logic I/O driver Ethernet/IP Adapter in combination with the Logic to SCADA connection driver.

  Summary It is not possible to use the zenon logic driver Ethernet/IP Adapter in combination with the Logic to SCADA connection driver. When starting the runtime following message appears: "Opening bus driver"T5EIPS" for cold resp. warm start ...

• 61850 GOOSE cannot be received if several adapters are listed

  Summary When a IEC61850 Server incl. GOOSE specified multiple Ethernet adapters for a GOOSE subscriber, the received values only on the first valid specified adapter where accepted. Description When a IEC61850 Server incl. GOOSE specified multiple ...

• EthernetIP Scanner overloads logic runtime when no connections are established

  Summary Ethernet IP Scanner with lost Connection leads to a cycle time increase until the Connection is reastablished. Description Ethernet IP Scanner with lost Connection leads to a cycle time increase until the Connection is reastablished. ...