The ALLENDF1 driver does not consider the TNS (Transaction counter), therefore when the driver receives several consecutively responses, it assigns the received values to the wrong data points.

• Related Articles

• Checklist: Data Missing in Service Engine

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• AllenDF1 driver: FLOAT and STRING variables show wrong values when the offset considers data type flag is active on driver configuration

  Summary In specific project configuration/offset constellation invalid Bit is set when a FLOAT variable is seen in a screen even if all offset configuration is correct. The problem occurs when in the driver configuration it is enabled the "Offset ...

• S7TCP32 driver stops if you read DATE AND TIME variable with wrong time values

  Summary The S7TCP32 driver stops if it reads a DATE AND TIME variable with a wrong time value. That means one of the following Byte values is out of range: Byte 3 - hour - crash with value 30 or higher Byte 4 - minute - crash with a value 90 or ...

• zenon Logic iec850-90-5 driver: in one cycle the Logic program can have data received by different frames of same sampled values.

  Summary zenon logic iec850-90-5 driver: no data integrity per one Logic cycle. Some variables from one data set may contain sampled values from the previous sample frame while other contain current values. Description zenon logic iec850-90-5 driver: ...

• Checklist: zenon Driver does not start in zenon 11 Engineering Studio / Service Engine.

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. In zenon 11 and newer versions, ...