T5BusExIec850m - Client - The driver always sends Cancel with value 0 on analog comands (APC)

• Related Articles

• iec850 driver in Cancel command is not using Test[CO] value set by user

  Summary IEC61850 Client driver in Cancel command service is not using */Oper.Test[CO] value set by user. In Operate and SelectWithValue services driver sends Test-flag correctly, in Cancel sends Test=0. Description IEC61850 Client driver in Cancel ...

• IEC850 Client driver in commands sends the time stamp with FractionOfSeconds = 0

  Summary IEC 61850 Client driver sends in commands - SBOw, Oper, Cancel - the time stamp but the FractionOfSeconds bytes (milliseconds) are 0. Description IEC 61850 Client driver sends in commands - SBOw, Oper, Cancel - the time stamp but the ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• FAQ: How can I browse an OPC UA Server using the zenon OPC UA Client Driver?

  Go to Drivers > New Driver Create a Driver of Type "OPC UA Client Driver" Open the Driver Configuration Go to "Connections" Create a new Connection Enter your Discovery URL Enter your Server URL manually or click the 3 dots to browse the Discovery ...

• iec850 driver does not set T_STD bit (bit 30) at variables with timestamp from t-attribute (T_EXTERN)

  Summary IEC61850 Client driver does not set the T_STD bit at the zenon variables getting external timestamp - from t-attribute (variables with FC= ST or MX, e.g. */stVal[ST]). The driver uses correctly T_STD bit but only by T_INTERN timestamps, not ...