T5BusEIP: Logic Service does not start on specific ARM64 devices when EtherNet/IP device fieldbus driver is configured

• Related Articles

• Interface settings for using an Ethernet port for Fieldbus communication in zenon Logic (e.g. ProfiNET)

  When using a local Ethernet interface for Fieldbus communication in zenon Logic, you have to ensure that VLAN and/or priority settings (cf. IEEE802.1Q) are deactivated in the network adapter configuration. Therefore, go to the Network controller ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• FAQ: Where can I find the XML device profile for COPA-DATA DNP3 drivers?

  What is a DNP3 XML device profile? Where can I find the XML device profile for one of the following drivers? DNP3_TG - Subset Level 1,2,3 and 4 for both requests and responses, DNP3 Master driver for zenon Service Engine AccessDNP3_SG - Subset Level ...

• New Ethernet/IP Scanner block to restart specific IO connection

  Logic Service fieldbus "Ethernet/IP Scanner" driver allows to restart IO connection of a specific EIP adapter (IP address) using the block EIPRESTARTCNX. The EIPRESTARTCNX block is available since zenon 10 build 138660. Refer to product documentation ...

• zenon Logic: Ethernet/IP Adapter and Ethernet/IP Scanner will not be started in Logic Service

  Description In zenon Logic ServiceEthernet/IP Adapter and Ethernet/IP Scanner are not started, although they were configured correctly in Logic Studio. When starting the Logic Service they are not started as expected. Diagnosis Viewer logs indicate ...