Symobls from the project symbol libarary are not loaded anymore when switching between projects

• Related Articles

• Checklist: Workspace/Project cannot be created, loaded or backed up

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Changes made to exported properties of a symbol from the global symbol library at a symbol in the local project library are not saved

  Summary When a symbol from the global symbol library that uses exported properties for some of its elements is used in a symbol of the local project library, changes to the exported properties are lost after restart of the editor. DescriptionWhen a ...

• Backup "before converted" restoring to same version that the project created cannot be loaded

  Description When switching to a newer version of the zenon software platform, a backup is created before converting a project when it is loaded. When trying to start this backup in the version for which it was created, an error message is displayed. ...

• Metering Point Administration Wizard may not start when no project is loaded

  Summary If no project is added to the open workspace, or no workspace is loaded while starting the Metering Point Administration Wizard, it may happen that the wizard does not work. Description If no project is added to the open workspace, or no ...

• IEC850 driver is not supporting anymore the 'Qualifier of Command' as Check value.

  Summary When in Command Processing module an action (e.g. 'switching command') has active property 'use Qualifier of Command' then, the value of 'QoC' configured in action, shall be used as 'Check' value in Operate and SelectWithValue (SBOw) and ...