Standby server freeze in redundancy while Euromap 63 driver is in hardware mode

• Related Articles

• Execution of "Redundancy switch" function does not work correctly in the runtime when using the hardware redundancy mode

  Summary When using the hardware redundancy mode in the project, the function "redundancy switch" does not execute properly in the runtime. The role of the active server does not switch after executing the function. DescriptionWhen using the hardware ...

• Primary Server may not find the Secondary Server on startup if the runtime is started simultaneously on both systems when using the hardware redundancy mode.

  Summary When the runtime is started simultaneously on both the primary server and the secondary server when using the hardware redundancy mode, the primary server may not find the secondary server and vice versa. After restarting the runtime on the ...

• OPC UA driver communication issue when switching driver status from Simulation mode to Hardware mode while SE running

  Description The OPC-UA driver does not communicate correctly with the OPC-UA server after switching from simulation mode to hardware mode and back to simulation mode while the Service Engine is running and the OPC-UA server is not connected. ...

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• Checklist: Client/Standby cannot establish a reliable connection with Service Engine Server

  Time estimate: 45 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...