SE: ETM - zoom out completly on Y axis - SE crashes

• Related Articles

• Extended Trend: Line Chart exceeds Y-Axis limit when another Gantt chart is active

  Summary When Gantt Bars where drawn, the curve "height" was extended with the height of the gantts and their gaps. Now the curves end always with the y-Axis. Description When Gantt Bars where drawn, the curve "height" was extended with the height of ...

• Filter settings Position "% of the width of the Y-Axis" in tab X-Axis is not configurable from -100 up to +100.

  Summary If you move down/up the X-Axis on the Diagram Window - trend display control, below/above allowed range, he will then see "message" on filter settings as long as he will not adapt it to the range 0-100. Without that, he cannot "save" ...

• Zoom in trend behaves different between specific zoom steps

  Summary Problem appears after 'Tick calculation >> Fitted ' is selected. Axis scale and grid get out of alignment with value of curve. Not predictable how much zoom is needed to trigger it. Description Problem appears after 'Tick calculation >> ...

• Web Visualisation Extended trend when curve not visible y axis is still visible

  Description If a curve has been added and removed via the curve visibility variable in the WVS Trend, the axis stayed visible. In addition, the scales were not correct. The issue has been fixed and the behavior is now as expected. To benefit from ...

• Extended Trend Screen can not be zoomed on the x-Axis (Time-Axis) if Lot Filter is applied directly

  Summary When displaying data based on a lot filter on an Extended Trend screen, you can not zoom on the x-Axis if the Lot Filter in the Screen Switch Function is set to "Apply Lot filter directly". Fix: Even when lot(s) are filtered directly, the ...