SAP: Maintenance Reports cannot be created (on certain days)

SAP: Maintenance Reports cannot be created (on certain days)

Description

Because of incorrect date formats, Maintenance reports could not be created via the zenon SAP interface.  When an alarm occurred that was configured to trigger a Maintenance report, an error message appeared in the Chronological Event List (CEL).
In addition to the bugfix it is strongly recommended that the SAP System uses the UTC time. 

The issue has been addressed and the behavior is now as expected.  


To benefit from this fix: 

  • Update your zenon Software Platform to the latest build of zenon 14 or higher. 



Item ID: 260544
Version: 15.00 Build: 440528
Version: 14.00 Build: 435445
    • Related Articles

    • Checklist: SAP Interface does not work

      Time estimate:  30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick ...
    • SAP maintenance reports don´t work

      Summary In the module SAP interface it is possible to define maintenance reports. They actually use the SAP function blocks  ALM_PM_MAINTNOT_CREATE ALM_PM_MAINTNOT_SAVE ALM_PM_MAINTNOT_MODIFY_DATA These are, however, not remote enabled with a ...
    • occasional unexpected shutdown of the zenon runtime when executing SAP maintenance reports

      Summary In rare cases it happens that the zenon runtime closes unexpectedly after sending a maintenance report to a SAP system. This is especially the case if a redundancy switch has been performed ealier. Description In rare cases it happens that ...
    • No logging for failed maintenance messages

      Summary When maintenance reports are used at the SAP Interface but creating the maintenance report in SAP fails (e.g. because of incorrect configuration), the log file does not provide information about this. Description When maintenance reports are ...
    • default tables for the Industiral Maintenance Manager (IMM) are not created

      Summary The names for the database tables used by the IMM are pre-defined and can not be changed in the zenon editor. However, these default names are not stored in the project.ini file. The zenon runtime, however, only created and accessed the ...