S7TCP32: Sending of consecutive requests (e. g. read-requests for an array (block) of variables) the driver takes about ~20ms until the next request is sent upon a response from the PLC

• Related Articles

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• 3S_V3 driver: If the values request from the PLC Handler takes too long, the RT will block.

  Summary If the values request from the PLC Handler takes more than a few seconds, the RT will block and a progress bar appears. Description If the values request from the PLC Handler takes more than a few seconds, the RT will block and a progress bar ...

• The DNP3_TG driver closes unexpectedly without an error message after receiving a specific response to a file transfer request.

  Summary The DNP3_TG driver closes without an error message when a specific outstation reports a file size 0xFFFFFFFF in a response to a file open request. In this particular case, the outstation reports 0xFFFFFFFF to indicate not a file size of 4GB ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• The OPCUA client driver stops sending service requests for a subscription when no variables are needed in the runtime and attempts to reuse the no longer existing subscription when a variable is needed again.

  Summary When momentarily no variables are used in the runtime from a connection in the OPCUA client driver, the OPCUA client driver no longer sends service requests for the subscribtion that was previously created for these variables. The OPCUA ...