S7TCP Driver has a higher CPU utilization in zenon 12 than in zenon 11

• Related Articles

• S5 TCP\IP has a higher CPU utilization in zenon 14 than in zenon 7.50

  Description The S5 TCP\IP had a higher CPU utilization in zenon 14 than in zenon 7.50. The issue has been addressed and the CPU utilization is now less than before and does not require the full performance of the core, when it is not needed. To ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Engineering Studio: Add Driver 'Siemens : S7 driver for S7-1200/1500' to Zenon Project - Error when starting driver

  Summary The S7TIA/S7 for S7-1200/1500 driver cannot be started. This issue has been solved. Description The attempt to add the driver S7TIA/S7 for S7-1200/1500 to a project fails in some constellations with an error message (Error code 0x8001011f). ...

• EUROMAP63: driver get stuck and cause high CPU load when dat file is wrong

  Description The EUROMAP63 driver hangs due to an error in the DAT file. Thereby it causes a high CPU load. The error is caused by unquoted ASCII fields and empty fields. These do not comply with the Euromap standard. This problem has been solved. The ...

• Checklist: zenon Driver does not start in zenon 11 Engineering Studio / Service Engine.

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. In zenon 11 and newer versions, ...