renaming the root node "Units" of the Batch Contrl tree has no effect
Summary
The module Batch Control has its own tree in the editor where unis and their phases are displayed. The root node of this tree can be renamed. This has, however, no effect as the modification is not stored.
Description
The module Batch Control has its own tree in the editor where unis and their phases are displayed. The root node of this tree can be renamed. This has, however, no effect as the modification is not stored.
Solution
The issue was fixed by prohibiting the renaming of the tree's root node.
Information
Issue Number: 33647
Fixed on Date: 30.6.2015
Versions: 7.50 0 BUILD 25796
Related Articles
Fieldbus configuration: uncomplete display in the tree for the root node
Summary In zenon Logic, some values are not displayed when reopening the Fieldbus configuration. This error has been fixed. Description In the "Fieldbus Configurations" editor, for entries in the tree of the root node, the names and values of the ...
Batch Control: Switch phase doesnt work properly for similar units
Summary In Batch Control, switching between phases of different units is not done correctly. This has been fixed. Description If control strategy is used in Batch Control, the parameters of the control strategy are retained when switching from one ...
If project is set to Windows CE, the node VSTA is still visible in the project tree
Summary If project is set to Windows CE, the node VSTA is still visible in the project tree, yet VSTA is not available under Windows CE. Description If project is set to Windows CE, the node VSTA is still visible in the project tree, yet VSTA is not ...
Since 7.50 in Equipment model the tree layout disappears while deleting some node in another window with Equipment model.
Summary The Equipment model may be opened simultaneously in two windows, e.g. from properties dialog and as general window. In that case when you delete a node in the tree opened form properties dialog then all the content in other window disappears. ...
The Editor may close unexpectedly when renaming a project with VBA disabled.
Summary The Editor may close unexpectedly after renaming a project through the project tree or the properties window when VBA is disabled in the zenon6.ini file. DescriptionThe Editor may close unexpectedly after renaming a project through the ...