Profinet Master - the configuration sent to the ET200SP with Profinet S2 is refused by the device

• Related Articles

• inconsistant usability behavior in zenon logic profinet device configuration

  Summary zenon logic profinet device configuration: there is an edit box instead of toggle check box when editing the master properties «　Initialize IOxS　» and «　I/O communication only from within cycle　» there is an edit box instead of a ...

• Interface settings for using an Ethernet port for Fieldbus communication in zenon Logic (e.g. ProfiNET)

  When using a local Ethernet interface for Fieldbus communication in zenon Logic, you have to ensure that VLAN and/or priority settings (cf. IEEE802.1Q) are deactivated in the network adapter configuration. Therefore, go to the Network controller ...

• FAQ: Where can I find the XML device profile for COPA-DATA DNP3 drivers?

  What is a DNP3 XML device profile? Where can I find the XML device profile for one of the following drivers? DNP3_TG - Subset Level 1,2,3 and 4 for both requests and responses, DNP3 Master driver for zenon Service Engine AccessDNP3_SG - Subset Level ...

• Profinet Device Malformed Packet on ReadModuleDiffBlock

  Summary In Logic fieldbus driver profinetIO Device on a request from controler 'ReadModuleDiffBlock' the Profinet Device return a malformed message (Invalid size). Description In Logic fieldbus driver profinetIO Device on a request from controler ...

• zenonLogic Profinet IO driver (master) does not start when reconnecting special device

  Summary With some profinet devices (in this case phoenix Contact Interbus / Profibus Gateway) there is a problem with the reconnect of the profinet driver. The Gateway sends a mismatch of modules to point on existing diagnosis messages. But it ...