Profinet device I/O driver T5BusPNIODev.dll In Straton does not start (#26720)

• Related Articles

• FAQ: Where can I find the XML device profile for COPA-DATA DNP3 drivers?

  What is a DNP3 XML device profile? Where can I find the XML device profile for one of the following drivers? DNP3_TG - Subset Level 1,2,3 and 4 for both requests and responses, DNP3 Master driver for zenon Service Engine AccessDNP3_SG - Subset Level ...

• zenonLogic Profinet IO driver (master) does not start when reconnecting special device

  Summary With some profinet devices (in this case phoenix Contact Interbus / Profibus Gateway) there is a problem with the reconnect of the profinet driver. The Gateway sends a mismatch of modules to point on existing diagnosis messages. But it ...

• Profinet Device Malformed Packet on ReadModuleDiffBlock

  Summary In Logic fieldbus driver profinetIO Device on a request from controler 'ReadModuleDiffBlock' the Profinet Device return a malformed message (Invalid size). Description In Logic fieldbus driver profinetIO Device on a request from controler ...

• Checklist: Engineering Studio cannot start or closes unexpectedly

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• When wrong configured Profinet driver stops the zenon Logic Runtime, the IEC61850 Server driver hangs

  Summary Circumstances under which this can happen: zenon Logic (straton) project has Profinet driver and IEC61850 Server driver the Profinet does not have correct Adapter identification so cannot start the iec850 server has all settings OK. Issue ...