PGW crashes if PGW is licensed but protocol module DNP3 Slave/Outstation isn't when trying to start it manually

• Related Articles

• AddIn does not start

  Check the Logs in DiagViewer. If it shows an ERROR in the GENERAL module which shows the exception: Scada.Internal.DotNetAddInExtension.AddInIntegration.Startup Cannot startup Add-In .NET Extension for instance id 'e1d3....'. Exception ...

• Checklist: Process Gateway cannot start

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Checklist: zenHelpService cannot start

  Time estimate: 15 minutes Please go through all the items in the following checklist. If necessary, confirm any information you cannot verify with the IT department before contacting your local COPA-DATA representative. If during the installation of ...

• FAQ: What can I do if the Service Engine does not start or is closed with an unhandled exception and the error message "(InitInstance (); an unnamed file has a bad format)" or "Init Instance (): an attempt was made to access an unnamed file past its end" is shown?

  This issue may occur due to missing digital certificates on the system where the error appears. Microsoft Windows implements a mechanism that automatically downloads, over the internet, trusted root certificate authorities, which are not installed ...

• Checklist: Engineering Studio cannot start or closes unexpectedly

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...