Performing "online change" in zenon logic after adding variables to zenon with activated option "externally visible" and reload of the zenon runtime the variables in zenon are not linked correctly to the corresponding variables in zenon logic. As a result, the added variables don`t have a value in zenon logic.

• Related Articles

• Externally visible variables are not updated in Logic if variablename is changed in lower-/uppercase

  Summary In zenon Logic externally visible variables were not updated under certain circumstances. This behavior has been fixed. Description If in zenon Logic variable names are modified only in upper/lower case, but the name itself remains the same, ...

• Variables from the STRATONNG driver receive status INVALID when performing an online change in the zenon logic

  Summary When performing an online change on downloading a new zenon logic project to the zenon logic runtime, variables from the STRATONNG driver become INVALID. Variables from the STRATON32 driver remain spontaneous DescriptionWhen performing an ...

• Writing a variable of the OPCUA client driver in the zenon logic via externally visible does not set the value correctly

  Summary With an OPCUA client driver in zenon and a variable that is set to "externally visible" writing this variable in a zenon logic program does not correctly send this value to the OPCUA server. Instead of the correct value, the value "0" may be ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• Defining externally visible variables for a specific zenon Logic project via the "Externally visible for" property in the zenon Editor does not work correctly.

  Summary If a variable has "Externally visible" enabled, entering the name of a specific zenon Logic project in the "Externally visible for" property should only display the variable in the defined Logic project. The variable in this case is available ...