Omron Hostlink driver (OMRON32) the driver doesn't convert BCD values for UDINT variables when the value is bigger then 9999

• Related Articles

• Setting values for DINT/UDINT variables of the S7_NT Driver from zenon runtime to PLC leads to value 0 in both zenon runtime and plc.

  Summary Setting values for DINT/UDINT variables of the S7_NT Driver from zenon runtime to PLC leads to value 0 in both zenon runtime and plc. This behaviour occurs when the following prerequisites are given: S7-Project created in Step 7 v. 55 ...

• When using a Driver in mode Simulation - programmed variables of type UDINT are not supporting values where the highest bit is set.

  Summary When using a Driver in mode Simulation - programmed and setting a value bigger than 2147483647 (7FFFFFFFh) on a variable of type UDINT in the zenon runtime the value will always be 2147483648 (80000000h). DescriptionWhen using a Driver in ...

• IEC61850 Server uses new TimeQuality value also for existing values of t-attributes

  Summary The zenon Logic I/O driver IEC61850 Server uses new TimeQuality (global setting) value also for already set values of t-attributes, i.a. for polled variables (not included in any Report) having t-attribute value from time before TimeQuality ...

• iec850 driver does not set T_STD bit (bit 30) at variables with timestamp from t-attribute (T_EXTERN)

  Summary IEC61850 Client driver does not set the T_STD bit at the zenon variables getting external timestamp - from t-attribute (variables with FC= ST or MX, e.g. */stVal[ST]). The driver uses correctly T_STD bit but only by T_INTERN timestamps, not ...

• iec870 driver does not transfer to SE new values of command variables if the old value had status bit OFF

  Summary The IEC 870 driver does not update values of command variables in the Service Engine if old variable values have status bit OFF. This behavior has been modified. Description The IEC 870 driver does not update the values of the command ...