MODBUSRTU: Priority Write and Read comand doesn't work

• Related Articles

• Checklist: Smart Client does not work

  Time estimate: 20 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• MELSECA driver cannot read/write file regster variables above offset 65535

  Summary MELSECA driver cannot read/write variables of object type file regster above offset 65535 If higher offsets are used it seem to work, but does not write on the correct address. Or the variable gets an invalid status. Description MELSECA ...

• FAQ: It seems that sometimes not all variables are correctly written to the PLC by the RGM module, although the system driver variable states that the recipe was written successfully and the option "write synchronously" is active. How can this be?

  When reading a RGM recipe immediately after writing a RGM recipe, with a driver that has the option "keep update list in memory" active, and recipe variables that have been read previously, it can happen that a read cycle is currently in progress, ...

• Cel print with Switch language in Sub Project from Integration Project doesn’t work.

  Summary Printing the CEL from a subproject after a language switch does not work correctly. In another language translated Keywords are not included in the Print. This behavior has been modified. Description In a project, the CEL is configured for ...

• FAQ: When I activate the option "write synchronously" for the Recipegroup manager recipe, and I write the recipe, the recipe does not seem to be written properly and also the Service Engine does not close properly. Why is that?

  When the option "write synchronously" is active at a recipe, when writing a recipe (sending values to the PLC) for each recipe variable a writing confirmation is requested to the driver. On a successfull write, the driver sends a writing confirmation ...