Metering point doesn’t set the RealtiveValueCalculation program in the logic

• Related Articles

• Creating new metering points with automatic value calculation is not possible. The output window displays the error "zenon logic project can´t be opened"

  Summary With the released version of zenon 7.50, in the 64bit editor, it is not possible to create new metering points with automatic value calculation. Instead, an error message is displayed, saying that the zenon logic project can´t be opened.  ...

• Metering Point Administration does not work with variables with Special characters in their names

  Summary The Metering Point Administration creates some zenon logic code to calculate the relative values. However, if either the absolute value variable or the relative value variable has special characters (like ä, ü, etc.) in its name, then the ...

• Automatic calculation of relative values by the Metering Point Administration does not work.

  Summary Even though metering points are correctly configured as automatic metering points with automatic relative value calculation, the calculation won't work. The value of the variable remains unchanged. In the windows task bar it can be seen that ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• relative values calculated by the metering point administration may be incorrect under certain conditions

  Summary The relative value that is computed by the metering point administration (or to be more precise by the VACO block in the zenon logic program) is reset to 0 after every archive cycle. If the absolute value changes at the exact same time when ...