MELSECA.exe driver Frame 3E, Optimized reading and writing sends more than 960 words if more than 15360 device points have been defined

• Related Articles

• MELSECA: When optimized reading datapoints of internal Relay M with an offset range between two or more variables >= 480 words (7680 bits) then driver behaves unexpectedly

  Description The MELSECA driver behaves unexpectedly when reading data points of the internal Relay M in an optimized way. Sporadically wrong values are displayed. This occurs in an offset range between two or more variables >= 480 words (7680 bits). ...

• FAQ: Where can I find the XML device profile for COPA-DATA DNP3 drivers?

  What is a DNP3 XML device profile? Where can I find the XML device profile for one of the following drivers? DNP3_TG - Subset Level 1,2,3 and 4 for both requests and responses, DNP3 Master driver for zenon Service Engine AccessDNP3_SG - Subset Level ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• MELSECA: Driver does not use maximum block size for read and write requests

  Summary The MELSECA driver does not use an optimized block size for reading and (block)writing variables in a consecutive address range. Description The MELSECA driver does not use an optimized block size for reading and (block)writing variables in a ...

• MelsecA - Q driver not writing all decimals for float numbers to PLC

  Summary Melsec A-Q driver (MELSECA.exe) writes only the integer part of a REAL number. For instance, if it is set 50.1 in zenon, in PLC it is only written 50. On reverse direction (PLC > zenon) the results are ok. Description Melsec A-Q driver ...