Logic DNP3 Fieldbus Variables Does Not Display or Send Negative Values

• Related Articles

• Interface settings for using an Ethernet port for Fieldbus communication in zenon Logic (e.g. ProfiNET)

  When using a local Ethernet interface for Fieldbus communication in zenon Logic, you have to ensure that VLAN and/or priority settings (cf. IEEE802.1Q) are deactivated in the network adapter configuration. Therefore, go to the Network controller ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• zenon Logic Fieldbus => Hilscher cifX Profibus: Diagnose Variables (Master/Slave) are not updated properly

  Summary zenon Logic Fieldbus => Hilscher cifX Profibus: Diagnose Variables (Master/Slave) are not updated correctly. it isn't possible to check/recognize, if a slave is ok or not ok, because the SlaveState Bit is always 0! => e.g disconnect the ...

• FAQ: After upgrading to version 8.00 or higher, I get an error during compilation of a Logic Service project: "K5BUSOPCUASRV: the configuration DLL file (\IOD) is not installed!" In the fieldbus configuration of the project, this driver is not visible.

  The K5BusOPCUASrv driver was discontinued with version 7.60 and has been replaced with a newer OPC UA Server implementation (K5BusOPCUA_s), available from version 8.00. Existing projects need to be adapted to this new driver. In order to remove the ...

• Fieldbus configuration: uncomplete display in the tree for the root node

  Summary In zenon Logic, some values are not displayed when reopening the Fieldbus configuration. This error has been fixed. Description In the "Fieldbus Configurations" editor, for entries in the tree of the root node, the names and values of the ...