iec870Slave (zenPG and Logic) is losing spontaneus value changes during GI

• Related Articles

• IEC 60870 Slave: wrong APDU Length calculation for series of M_ME_TC_1 (T14) and M_ME_TF_1 (T36) data

  Summary issue in Stack for IEC60870 Slave - in zenon Process Gateway and in zenon Logic - when driver is used with reduced setting for 'ADPU/Data size': for IOs (variables) of Type IDs: - T14 - M_ME_TC_1 - measured value, short floating point number ...

• Compatibility problem with Access IEC60870-5-104, can't load setting from XML

  Description After updating zenon Software Platform to a build that supports IPv6, IEC870 Master does not get a connection to IEC870 Slave in 101-Unbalanced mode.. This has been fixed. To benefit from this fix: Update your zenon Software Platform to ...

• IEC61850 Server sends GI Report before ourstanding Report with current data changes

  Summary For Unbuffered and Buffered Reports the IEC61850 Server can be configured to summarise in single Report all value changes of different attributes for BufTm period. When during the BufTm interval the same attribute (variable) changes the value ...

• File transfer in control direction for the IEC60870 slave for zenon logic

  Summary Is file transfer in control direction supported for the IEC 60870 slave for zenon logic? Description Is file transfer in control direction supported for the IEC 60870 slave for zenon logic? Solution The IEC 60870 slave for zenon logic has ...

• Checklist: The Logic Service to Service Engine connection does not work

  Time estimate:   30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...