IEC870 driver (Master) and zenPG IEC870Sl should support file transfer also in control direction.

• Related Articles

• File transfer in control direction for the IEC60870 slave for zenon logic

  Summary Is file transfer in control direction supported for the IEC 60870 slave for zenon logic? Description Is file transfer in control direction supported for the IEC 60870 slave for zenon logic? Solution The IEC 60870 slave for zenon logic has ...

• New functionality implemented for the DNP3_TG driver: Subset Level 4+ master including DNP3 file transfer

  Summary The DNP3_TG driver is a Subset level 2 master and does not support DNP file transfer Description The DNP3_TG driver is a Subset level 2 master and does not support DNP file transfer Solution The DNP3_TG driver has been enhanced with ...

• Checklist: Message Control

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• IEC850: A dump occurs after a File transfer GET* command on a specific IED server.

  Note: For this bug, the solution from Bug 250843: IEC850: Driver crash when executing GETALL, GETDIFF and GETNEW commands in Service Engine which adressed zenon 11 and 12 was applied to zenon10. Summary The IEC850 driver (850-client) can terminate ...