IEC870 driver in connection redundancy ed.2.0: missing resent of GI activation after connection switch

• Related Articles

• Checklist: Data Missing in Service Engine

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• iec870 driver in redundancy Ed.2: test-frames (TESTFR) are causing delays 20-30s in the switch (STARTDT) to alternative IP

  Summary IEC870 driver - Issues with edition 2.0 redundancy. Delayed manual redundancy switch when the active connection was broken. Description IEC870 driver - Issues with edition 2.0 redundancy. Delayed manual redundancy switch when the active ...

• IEC850 Client driver when switches or reconnects and RCB is (still) enabled doesn't send GI nor polls variables

  Summary Issue when IEC61850 Client driver (zenon driver or Logic I/O driver) are configured to use redundant IP addresses or by reconnect - when IED does not set free RCBs; when after connection loss, on IED, the RptEna stay TRUE. When previously the ...

• IEC870 driver: redundancy according to IEC60870-5-104 Edition 2 can lead to not acknowledged frames

  Summary During the redundancy switch between primary and secondary IP in IEC60870 driver (Master) - according procedure introduced by Edition 2 of the IEC60870-5-104 Standard - the slave can still send some frames. But when the procedure starts - ...

• DNP3_TG: Driver does not / cannot switch to redundant connection under specific circumstances

  Summary DNP3_TG driver does not switch to redundant connection under certain circumstances. This has been fixed. Description DNP3_TG driver does not switch to the redundant connection if the TCP connection to a Terminal Server is established but the ...