Extended Trend: Converting a project from 7.xx to 8.00 the curvename automaticaly will set to variable name but in 7.xx the curve name was always static

• Related Articles

• The curve name in extended trend is cut if longer than the defined colum size

  Summary In the screen switch function for an extended trend when adding a curve with the name like: 'MPLC.TSMU/AscentSys.VacuumPumps.P1.ACP_Inverter.Cmd.test' it will be cut to 'MPLC.TSMU/AscentSys.VacuumPum' Description In the screen switch function ...

• Archive variable selection in the Service Engine for the extended trend, the selection table is always set to the default state.

  Summary In the Service Engine, in the Extended Trend screen, the columns in the table for selecting archive variables are always reset to the default state. This behavior has been adjusted. Description In the Service Engine, the columns in the table ...

• TREND: Multi-select changes to curves renames all curves to the same name as the first curve.

  Summary In the Extended Trend, curves are erroneously renamed when multiple selections are made. This bug has been fixed. Description In the screen switch dialog to an Extended Trend, when editing multiple curves the static curve names are ...

• It may occur that the curve list columns of the extended trend screen cannot be changed in the webclient runtime.

  Summary The name and title columns of the curve list in the extended trend screen cannot be changed in the webclient runtime. Description The name and title columns of the curve list in the extended trend screen cannot be changed in the webclient ...

• Extended Trend curves not displaying when first curve is not active

  Summary When a Extend Trend screen displays more than one curve, if the first curve is disabled by the user (active off) and the remaining curves are still active, these also aren't shown >> Are also cleared from the trend. Note: this only occurs if ...