ETM cursor output list displays incorrect value for minimum and maximum

• Related Articles

• ETM: the cursor output list only shows the amount of curves which were active when switching to the ETM screen. When more curves are activated / deactivated the cursor output list does not show a proper amount of curves and wrong values.

  Summary The cursor output list always shows the amount of curves which were set active in the screen switch function. When curves are activated / deactivated in the ETM screen the output list is refreshed but always shows the same amount of curves. ...

• ETM: Cursor output window only shows data until "now", not from curves that are in the future.

  Description If a time filter in the ETM is set in the future, the cursor output window only displayed data until "now", but not from curves that are in the future. The issue has been addressed and now the correct values are displayed in the cursor ...

• ETM: cursor output in diagram only works if screenswitch has active curves

  Summary For a diagramm with integrated scan list, on "Cursor on" each active curve is shown in the scan list, regardless of how many curves were activated in the screen switch function. Description For a diagramm with integrated scan list, on "Cursor ...

• ETM: Y-Axis automatic scaling changes value range

  Description In the ETM the Y-axis changed automatically the scaling range, if the value of the variables was changed a few times. This happened because no value change was found and so the default scale of +- 10% of the variable value range was ...

• Variable identifier is not translated in the “Cursor output field”

  Description When the language was switched, the Variable identifier was not translated in the “Cursor output field”. The issue has been addressed and the Variable identifier is now also translated. To benefit from this fix: Update your zenon Software ...