ES: Linked macros and wizards settings get lost if you open settings dialog again

• Related Articles

• Checklist: VBA Editor does not start neither wizards

  Time estimate:    15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Check if zenWorkspace.vba is ...

• Checklist: VSTA IDE: "Error: Unable to create macro projects. Is the correct project template installed?"

  Time estimate:   15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. For yet unknown reason the path ...

• Distributed Engineering. Alarm Areas linked to an Equipment Model get lost after synchronization.

  Summary At the zenon Editor (x86 & x64) with a multiuser global and standard project, alarm areas in the standard are lost after synchronization if they are linked to a global equipment group. Description At the zenon Editor (x86 & x64) with a ...

• Distributed Engineering. After synchronization with the server the changes of the screen settings get lost.

  Summary When a multiuser project was created and activated the gesture recognition settings of a screen and accept the changes. After the synchronization with the server the before establish modification are gone. This behavior only appears with the ...

• Filter settings on curves list in extended trend filter are reset after Add/Edit/Delete curve

  Summary On curves list in extended trend filter the settings lost filter settings if the configuration dialog is open. DescriptionOn curves list in extended trend filter the settings lost filter settings if the configuration dialog is open. Solution ...