New Ethernet/IP Scanner block to restart specific IO connection

• Related Articles

• zenon Logic: Ethernet/IP Adapter and Ethernet/IP Scanner will not be started in Logic Service

  Description In zenon Logic ServiceEthernet/IP Adapter and Ethernet/IP Scanner are not started, although they were configured correctly in Logic Studio. When starting the Logic Service they are not started as expected. Diagnosis Viewer logs indicate ...

• The Ethernet IP I/O Scanner does not reconnect properly if several Adapters are connected and rebooted

  Summary In case of a network loss or Ethernet IP adapter is unpowered, it could happen in installations >3 Ethernet IP adater that some of the adapters are not reconnecting properly. Description In case of a network loss or Ethernet IP adapter is ...

• EthernetIP Scanner overloads logic runtime when no connections are established

  Summary Ethernet IP Scanner with lost Connection leads to a cycle time increase until the Connection is reastablished. Description Ethernet IP Scanner with lost Connection leads to a cycle time increase until the Connection is reastablished. ...

• It is not possible to use the zenon logic I/O driver Ethernet/IP Adapter in combination with the Logic to SCADA connection driver.

  Summary It is not possible to use the zenon logic driver Ethernet/IP Adapter in combination with the Logic to SCADA connection driver. When starting the runtime following message appears: "Opening bus driver"T5EIPS" for cold resp. warm start ...

• EIP Scanner: Performing Online change in zenon Logic causes the EIP communication to break

  Description In zenon Logic the Ethernet/IP Adapter aborts the communication when online changes are performed in the Ethernet/IP Scanner. The communication cannot be restored. This error has been fixed. If the connection is interrupted, it is ...