Dynamic content for Message Control welcome message when using Text To Speech

• Related Articles

• The Text To Speech voice selection of Message Control is ignored and the default voice is taken instead

  Summary The Text To Speech voice selection of Message Control is ignored and the default voice is taken instead. Regardless of the setting in the Text To Speech node, the default voice is used. Description The Text To Speech voice selection of ...

• Text-To-Speech sending method ignores the "Time Between Attempts" setting

  Summary Message Control messages that use Text-To-Speech as sending method are not using the "Time between attempts" setting from the Message Control node in the editor. This can cause messages after the first one not to be transmitted because ...

• Checklist: Message Control

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• FAQ: What are the modems successfully tested with zenon Message Control?

  The list of tested modems is available in the pdf file attached. Unfortunately, old analog voice modems are rare on the market and the drivers for these devices are not available for actual operating systems like Windows 10, Windows Server 2016, etc. ...

• Acknowledging messages in Message Control over SMTP does not work correctly when mails use text MIME type

  Summary When an acknowledged message reaches Message Control that is not using text format but a text MIME type, Message Control is unable to acknowledge the message properly. Description When an acknowledged message reaches Message Control that is ...