Driver programmed simulation - strings do not work (all strings contain 1" as text) "

• Related Articles

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• "Invalid project folder" error message is displayed on creating a zenon logic project for programmed simulation with certain drivers

  Summary With certain drivers it is not possible to create a zenon logic project for the programmed driver simulation. An error message is displayed: "invalid project folder" This concerns the following drivers: 3S_32 3S_Arti 3S_Arti_NG 3S_V3 3964R32 ...

• Checklist: Smart Client does not work

  Time estimate: 20 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Writing empty strings using Blockwrite and the setting "CHAR without header" with the S7TCP32 driver does not work correctly

  Summary When using the S7TCP32 driver with blockwrite active, writing empty "CHAR without header" strings using e.g. recipe group manager, writes the empty string variables with the last used non-empty string value. Description When using the S7TCP32 ...

• When using a Driver in mode Simulation - programmed variables of type UDINT are not supporting values where the highest bit is set.

  Summary When using a Driver in mode Simulation - programmed and setting a value bigger than 2147483647 (7FFFFFFFh) on a variable of type UDINT in the zenon runtime the value will always be 2147483648 (80000000h). DescriptionWhen using a Driver in ...