Driver Crash 3S_V3.exe has stopped working" when switching to mode hardware and writing values"

• Related Articles

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• OPC UA driver communication issue when switching driver status from Simulation mode to Hardware mode while SE running

  Description The OPC-UA driver does not communicate correctly with the OPC-UA server after switching from simulation mode to hardware mode and back to simulation mode while the Service Engine is running and the OPC-UA server is not connected. ...

• Checklist: Hardware-dongle is broken

  Time estimate: 5 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• relative counters created with the Metering Point Administration suddanly stopped working

  Summary The Metering Point Administration allows creating relative counters which calculate the (e.g. energy) consuption within a specific time period based on the value of the linked absolute counter variable. However, the calculation of the ...

• Variables of OPC2CLI32 driver get invalid when the OPC2CLI32 driver is started in Simulation - static mode and then switched to Hardware mode during runtime

  Summary When starting the OPC2CLI32 driver in mode Simulation - static and then switching to mode Hardware during runtime, the variables of the OPC2CLI32 driver become invalid. Description When starting the OPC2CLI32 driver in mode Simulation - ...