Does the S7TIA driver support communication with Siemens PLCs with TIA21 projects and current 4.1.x firmware?

• Related Articles

• FAQ: Why does the communication with a Siemens TIA PLC with TIA 20 and firmware 4.0 fail under specific circumcstances?

  The communication using the S7TIA driver with Siemens TIA PLCs with TIA portal version 20 and firmware version 4.0 may fail under specific circumstances when combinations of variables are read. This issue has been addressed by Siemens from firmware ...

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• Is zenon affected by the vulnerabilities in Siemens S7 PLCs?

  Vulnerabilities have been discovered in a range of Siemens PLCs that may lead to a full compromise of the PLCs affected. In the bulletins SSA-568427 and SSB-898115, Siemens recommends updating PLCs to a current firmware version, migrating the ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Communication Reset after one hour for the TIA driver with firmware 3.0

  Description If the TIA driver is operated with firmware 3.x, the PLC performs a reset in the Service Engine after one hour of operation. Communication is interrupted and restarted. This reset always occurs again after one hour. This behavior has been ...