DNP3_TG driver: Setting link status request interval to "0" results in constant link status requests being sent

• Related Articles

• FAQ: How can I monitor and react on the communication status of my devices with zenon?

  Data quality is very important to the integrity of a HMI or SCADA system. As such, zenon has numerous ways to monitor the communication status of different devices within your automation environment. Here are some options that you can use in your ...

• The DNP3_TG driver closes unexpectedly without an error message after receiving a specific response to a file transfer request.

  Summary The DNP3_TG driver closes without an error message when a specific outstation reports a file size 0xFFFFFFFF in a response to a file open request. In this particular case, the outstation reports 0xFFFFFFFF to indicate not a file size of 4GB ...

• DNP3_TG: Driver does not / cannot switch to redundant connection under specific circumstances

  Summary DNP3_TG driver does not switch to redundant connection under certain circumstances. This has been fixed. Description DNP3_TG driver does not switch to the redundant connection if the TCP connection to a Terminal Server is established but the ...

• OPCUA32: Sampling Interval setting is ignored

  Summary The driver setting "sampling interval" has no effect in the runtime. Always the value "0" is used. Description The driver setting "sampling interval" has no effect in the runtime. Always the value "0" is used. Solution The configured sampling ...

• DNP3_TG driver as DNP3 master with dual endpoint does not correctly accept unsolicited responses from an outstation initiated connection.

  Summary With a DNP3_TG driver configured for use with a dual endpoint, after the master initially established a connection and closed the connection again due to inactivity after the idle timeout, an outstation can successfully connect to the ...