Display issues with the Metering Point Administration when Windows display setting is not 100%

• Related Articles

• Metering Point Administration does not work with variables with Special characters in their names

  Summary The Metering Point Administration creates some zenon logic code to calculate the relative values. However, if either the absolute value variable or the relative value variable has special characters (like ä, ü, etc.) in its name, then the ...

• No warning when overwriting archive values with the help of the Metering Point Administration

  Summary The Metering Point Administration allows to write values into an archive by entering a new manual value or by entering a meter replacement. In the latter case it would, however, not display a warning in case there already exists an entry with ...

• Metering Point Administration : creation of valuecalculation is broken.

  Description After using the Metering Point Administration Wizard to create an archive and a relative value, the generated zenon Logic project did not contain all the necessary variables to function correctly. The issue has been addressed and the ...

• Automatic calculation of relative values by the Metering Point Administration does not work.

  Summary Even though metering points are correctly configured as automatic metering points with automatic relative value calculation, the calculation won't work. The value of the variable remains unchanged. In the windows task bar it can be seen that ...

• Checklist: Multimonitor administration

  Time estimate:  15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. zenon configuration file ...