DATEI32v2 driver: Reading binary v2 file fails - message unknown datatype

• Related Articles

• Cannot create a CTI variable using driver object type V Memory

  Summary In zenon 7.10 Editor (32 & 64 bit), if you have a pre-existing CTI variable, you cannot change its driver object type from K-memory to V-memory. Note: Even with creating a new variable based on CTI driver, V Memory object Type, REAL Datatype, ...

• The DNP3_TG driver closes unexpectedly without an error message after receiving a specific response to a file transfer request.

  Summary The DNP3_TG driver closes without an error message when a specific outstation reports a file size 0xFFFFFFFF in a response to a file open request. In this particular case, the outstation reports 0xFFFFFFFF to indicate not a file size of 4GB ...

• Checklist: Message Control

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• FAQ: What can I do if the Service Engine does not start or is closed with an unhandled exception and the error message "(InitInstance (); an unnamed file has a bad format)" or "Init Instance (): an attempt was made to access an unnamed file past its end" is shown?

  This issue may occur due to missing digital certificates on the system where the error appears. Microsoft Windows implements a mechanism that automatically downloads, over the internet, trusted root certificate authorities, which are not installed ...

• FAQ: What are the modems successfully tested with zenon Message Control?

  The list of tested modems is available in the pdf file attached. Unfortunately, old analog voice modems are rare on the market and the drivers for these devices are not available for actual operating systems like Windows 10, Windows Server 2016, etc. ...