CTI driver not communicating in zenon 10

• Related Articles

• Checklist: Communication to TwinCat via BeckhoffNG driver

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. TwinCAT ADS communication library ...

• Cannot create a CTI variable using driver object type V Memory

  Summary In zenon 7.10 Editor (32 & 64 bit), if you have a pre-existing CTI variable, you cannot change its driver object type from K-memory to V-memory. Note: Even with creating a new variable based on CTI driver, V Memory object Type, REAL Datatype, ...

• Checklist: zenon Driver does not start in zenon 11 Engineering Studio / Service Engine.

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. In zenon 11 and newer versions, ...

• Service Engine: S7TIA Driver - crashes on reconnect PLC

  Description The Service Engine has a connection to a S7TIA PLC. If the Service Engine loses the connection and the variables get the status "invalid", the S7TIA Driver is terminated unexpectedly after reconnecting. This error has been fixed. To ...

• The iLON100 driver behaves unexpected when it either starts communicating in the zenon runtime or when creating a new connection within the driver configuration.

  Summary When creating a new connection with the iLON100 driver or when the iLON100 driver starts communicating in the zenon runtime the iLON100 driver behaves unexpected. DescriptionWhen creating a new connection with the iLON100 driver or when the ...