CNetDrv: Sequence number in acknowledge message should be the same as the sequence number in the SOE response

• Related Articles

• sequence may fail if in previous sequence the second stage of action was aborted on interlocking

  Summary Command Sequencer does not release NET_SEL bit if sequence is aborted in two-stage action when an interlocking appears before Execute2. As consequence the response variable stays (10s) allocated and blocks execution of next sequence using it. ...

• Acknowledge ground fault message and short-circuit message without linked variable create unnecessary output windows messages

  Summary "Acknowledge short-circuit message" function causes misleading warnings in the output window. This has been fixed. Description If in an energy project the "Acknowledge short-circuit message" function is used without linking it to a variable, ...

• Checklist: Message Control

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Screenshot and followed ...

• The DNP3_TG driver closes unexpectedly without an error message after receiving a specific response to a file transfer request.

  Summary The DNP3_TG driver closes without an error message when a specific outstation reports a file size 0xFFFFFFFF in a response to a file open request. In this particular case, the outstation reports 0xFFFFFFFF to indicate not a file size of 4GB ...

• FAQ: What are the modems successfully tested with zenon Message Control?

  The list of tested modems is available in the pdf file attached. Unfortunately, old analog voice modems are rare on the market and the drivers for these devices are not available for actual operating systems like Windows 10, Windows Server 2016, etc. ...