Can I map the IEC 60870 statusbits not topical and overflow to the INVALID status bit in zenon, using the IEC870 driver?

• Related Articles

• FAQ: How can I monitor and react on the communication status of my devices with zenon?

  Data quality is very important to the integrity of a HMI or SCADA system. As such, zenon has numerous ways to monitor the communication status of different devices within your automation environment. Here are some options that you can use in your ...

• Checklist: Driver(s) cannot establish a reliable communication

  Time estimate: 60 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Process Gateway IEC870Slave should map status bit ALT_VAL of variable to flag 'Substituted'

  Summary When zenon variable has ALT_VAL status bit (bit 27) the Process Gateway iec870Slave sends value changes in ASDU with quality descriptor flag IV ('invalid') or NT ('not topical'). It should send, in quality descriptor in ASDU, the flag SB - ...

• BuRPVI driver: all Driver variables have invalid (I-Bit) status

  Summary All variables from object type Driver variable of the BuRPVI driver get an invalid status. No error in the diagnosis viewer logged. Description All variables from object type Driver variable of the BuRPVI driver get an invalid status. No ...

• Service Engine: S7TIA Driver - crashes on reconnect PLC

  Description The Service Engine has a connection to a S7TIA PLC. If the Service Engine loses the connection and the variables get the status "invalid", the S7TIA Driver is terminated unexpectedly after reconnecting. This error has been fixed. To ...