BACnetNG: Driver does not finish reading trendlog object before starting to read another trendlog with maxconcurrentrequest=1

• Related Articles

• The BACnetNG driver should support TrendLog variables.

  Summary TrendLog variables should be supported by the BACnetNG driver. DescriptionTrendLog variables should be supported by the BACnetNG driver. Solution The BACnetNG driver now supports TrendLog variables. Issue Number: 36601 Fixed on Date: ...

• BACnetNG: while using trend logs, if a variable with wrong object name is being requested and the driver can´t retrieve any data, all following variables are skipped

  Description For the BACnetNG driver, if trendlogs from a variable with an incorrect object name are requested and can not be received, all following variables from the same device will not be requested. This issue has been addressed and the following ...

• Engineering Studio: Add Driver 'Siemens : S7 driver for S7-1200/1500' to Zenon Project - Error when starting driver

  Summary The S7TIA/S7 for S7-1200/1500 driver cannot be started. This issue has been solved. Description The attempt to add the driver S7TIA/S7 for S7-1200/1500 to a project fails in some constellations with an error message (Error code 0x8001011f). ...

• LSIS Driver doesn't fit the read/write address If variable create the bool type.

  Description The LS Industrial Systems XGT driver (LS_XGT) does not use the correct read/write address for variables of type Bool. The driver writes to a different address than it uses for reading. This behavior depends on the configured type. This ...

• Deleting of an Referenced Smart Object Template causes Zenon to Crash

  Summary Deleting a referenced Smart Object Template (SOT) causes zenon to exit unexpectedly. This error has been fixed. Description A SOT contains a zenon Logic project and a variable that is externally visible for zenon Logic. This SOT is referenced ...