ALLENDF1 driver: Simulation mode warning message at start the runtime

• Related Articles

• FAQ: What are the different zenon drivers modes?

  All Service Engine process-driven drivers can run in four different modes, mainly allowing you to switch between active hardware connection and values simulation. While "Hardware" allows establishing a connection to the target device(s) and its the ...

• FAQ: What can I do if the Service Engine does not start or is closed with an unhandled exception and the error message "(InitInstance (); an unnamed file has a bad format)" or "Init Instance (): an attempt was made to access an unnamed file past its end" is shown?

  This issue may occur due to missing digital certificates on the system where the error appears. Microsoft Windows implements a mechanism that automatically downloads, over the internet, trusted root certificate authorities, which are not installed ...

• Checklist: zenon Driver does not start in zenon 11 Engineering Studio / Service Engine.

  Time estimate: 15 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. In zenon 11 and newer versions, ...

• Checklist: Engineering Studio cannot start or closes unexpectedly

  Time estimate: 30 minutes Please go through all the points in the following checklist. If necessary, confirm with IT Department any information you cannot verify before contacting your local COPA-DATA Representative. Checklist usage: #. [Quick hints] ...

• Variables of OPC2CLI32 driver get invalid when the OPC2CLI32 driver is started in Simulation - static mode and then switched to Hardware mode during runtime

  Summary When starting the OPC2CLI32 driver in mode Simulation - static and then switching to mode Hardware during runtime, the variables of the OPC2CLI32 driver become invalid. Description When starting the OPC2CLI32 driver in mode Simulation - ...